Compex LinkPort ENET-C Manual do Utilizador descarregar pdf (Página 6)

Using PortShield Interfaces

Configuring PortShield Interfaces

SonicOS Enhanced 3.1 Release

From Both the Interfaces and Switch Ports Environments

To create a PortShield interface using the from both the interface and switch ports environments, you

perform the following tasks:

1. Establish a management session with the SonicWALL PRO 1260 device and access the Interfaces

environment.

2. Create and add a PortShield interface to the Interface list.

3. Go to the Switch Port environment and assign ports to the PortShield interface you created.

4. You can select ports for your PortShield interface in one of the following ways:

–

from the device graphic.

–

from the dialog box displayed by clicking on the pen and paper icon (the same dialog box

displayed in the Interface environment).

From the PortShield Interface Wizard

To create a PortShield interface using the PortShield wizard, you perform the following tasks:

1. Establish a management session with the SonicWALL PRO 1260 device.

2. From one of the environments listed here, launch the PortShield interface wizard. You can select the

PortShield interface wizard from one of the following environments:

–

the System > Status page - the default environment (Wizards button located in the top-right

corner).

–

the Network > Interfaces page (Wizards button located in the top-right corner)

–

the Network > Switch Ports page (PortShield Wizard button located in the top-right corner)

–

the Wizards page (PortShield Interface Wizard radio button displayed by clicking on the

Wizards option in the navigation pane)

3. Navigate through the wizard screens, selecting and verifying one of the options presented for switch

partitioning, which divides the ports up into preset ranges and enables IP address assignment to the

interface.

Understanding IP Assignment Modes

You can use two different types of address assignment modes to create PortShield interfaces. They are

Static and Transparent. Each has benefits to it depending on the number of addresses you want to assign

to a PortShield interface. The following two sections describe each.

Working in Static Mode

When you create a PortShield interface in Static Mode, you manually create an explicit address to be

applied to the PortShield interface. All ports mapped to the interface are identified by this address. Static

mode is available on interfaces assigned to Trusted, Public, or Wireless zones. This approach is

appropriate if you are configuring only one address for a PortShield interface as it gives you more

control over the address selected while not taking a lot of time to manually make the assignment.

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Comentários a estes Manuais

Sem comentários

Compex LinkPort ENET-C Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Compex LinkPort ENET-C