Compex NetPassage WP18 Guia de Instalação Página 1

Quick Install Guide Wireless 54Mbps A+G Dualband Access Point With Integrated PoE NetPassage WP18 1A, 2A, 2B, 2C, 3A, 3B, 3C, 3D NetPassage WP18

8 3: Access to Web Interface There are 2 methods to access the web interface of the access point: 1. Access to the Web Interface Through Utilit

9 Access to the Web Interface Through Utility - uConfig The powerful uConfig utility provides convenient access to the web configuration page. I

10 Select the access point in the products list section and click on Open Web button. To update and display the available device(s) in the list,

11 This screen prompts you not to exit your uConfig program while accessing to your web interface, or else you will fail to connect to your devic

12 You will then reach the home page of the access point web interface. Note: Refer to User’s Manual for detailed instructions on configuring t

13 4: Panel Views and Descriptions Front View in standing position 1 7 2 3 4 5 6 Rest feet attached to the bottom ofthe access point

14 Side View in standing position 7 8 9 10 11 12

15 Panel Description Name Description Steady Green The device is powered up. 1 Power (LED) Off No power is supplied to the device. Steady Gr

16 6 Rest Feet These rest feet hold the access point in the standing position. 7 External Antennas SMA antennas 8 R232 (Integrated Serial In

17 5: Technical Specifications Safety and Electromagnetic Conformance • FCC Part 15 SubPart B and SubPart C [for wireless module] • EN 300 328

i Table of Contents 1: Introduction...1 Packaging Content...

18 Network Interface WAN Interface: 1 x 10/100 Mbps LAN Interface: 3 x 10/100 Mbps Power over Ethernet: 1 x PoE Security • 64 - bit / 128

19 Certifications • FCC • CE Mark • Gost • C-tick N 12030 Environment Requirements Operating Temp: Storage Temp: Operating Humidity: 0ºC

20 Disclaimer: Compex, Inc. provides this guide without warranty of any kind, expressed or implied, including but not limited to the implied warra

21 WARRANTY REGISTRATION CARD Register via the Internet at http://www.cpx.com or http://www.compex.com.sg [M-0088-V2.4C] To activate the warranty

Manual Number: M-0508-V1.3C Version 1.3 December 2006

1 1: Introduction The Wireless 54Mbps A+G Dualband Access Point doesn’t just operate in wired network environments, it also upholds simultaneous

2 Packaging Content Actual product appearance may differ slightly depending on the hardware version. 1 X Access Point 2 x External Antenna

3 ! Important: To ensure proper functionality of theaccess point, these two antennas MUSTNOT be swapped. 2: Hardware Setup The access poin

4 Insert one end of the RJ45 Ethernet cable to any of the LAN ports (1, 2, 3, or 4) on the access point and the other end to your PC’s Ethernet n

5 Option 2: Using PoE to Supply Power PoE (Power-Over-Ethernet) can be used to power the access point. This accessory supplies operational power t

6 Connect the RJ45 Ethernet cable attached to the PoE Injector to your PC’s Ethernet network adapter. Once you have finished configuring the acc

7 Turn on your power supply. Notice that the Power LEDs have lighted up. This indicates that the access point is receiving power through the PoE